Solenoids can be buried in a special enclosure, or wall mounted in a convenient location.
Each manifold is built to specific requirements. The design enables setting up any number of solenoids. Connection to the water supply can be made through either end with a blanking cap sealing one end. This cap can be removed, and the manifold extended by using Male and Female fittings (25.4 mm) for extra solenoids. Whether connected to a garden tap or a pumped system, the solenoid manifold retains the same configuration.
Tip: When installing solenoid wires, allow for all possible future expansion requirements.
ja jalleen pilattu sivu, kive tuhota omaa tyotaan
SOLENOID VALVES
Solenoid valves work in conjunction
with the EC, SRC & ICC controllers.
Each solenoid controls one zone, the controller supplies a 24V actuating voltage
to the solenoid for it to open.
After the required amount of time has passed the controller turns off the supply
to the solenoid, closing it.
Transferring the power to the next station opening each solenoid in sequence.
HPV
& PGV are high-grade construction made of durable PVC and stainless
steel to resist wear. Manual bleed keeps the valve box dry. Heavy-duty solenoid
provides dependable operation and long life. Flow control allows greater versatility
of operation.
The HPV is used in higher-pressure
systems. Professional grade valves that can cope with dirty water. The integral
flow control allows for greater versatility of operation.
HPV High Performance
With
low flow capabilities the HPV is suitable for tap (mains)
fed systems.
High-grade
valve developed for domestic and residential systems.
PGV Professional grade
Featuring
rigid diaphragm support to prevent stress failure in
tough conditions.
Designed
to pressures up to 150 psi, the PGV is ideal for pumped
systems.
